801.590.6832
Service Call Request
What's New
Welcome to the new web site. Please look through our services to see if we can help you, send us a message for a quote on work or just to say hello.
Monthly Maintenance 20 Point Checklist Plumbing, Heating, & Cooling Maintenance for Utah Homeowners
Air Conditioning Tune-up, and Safety Inspection
Tune-up your air-conditioner and Neerings will guarantee you a 100% profit in energy savings – or your money back!
Trained Neerings technicians will perform a 60-90 minute precision tune-up and professional cleaning including the following 19 operations:
- Blower Motor – measure amperage and voltage for proper operation
- Thermostat – test for proper operation, calibrate and level
- Clean existing air filter
- Bearing – inspect for wear and lubricate
- Condensate Drain – flush and treat with anti-algae
- Inspect Condenser Coil
- Refrigerant
- Safety Devices – inspect for proper operation
- Electrical Disconnect Box – inspect for proper rating and safe installation
- Electrical Wiring – inspect and tighten connections
- Test/inspect contactors for burned, pitted contacts
- Inspect electrical for exposed wiring
- Inspect and test capacitors
- Inspect fan blade
- Clean condenser coil and remove debris
- Inspect service valves
- Measure Supply/Return temperature differential
- Inspect duct work for energy loss - If accessible
- Compressor – monitor, measure amperage and volt draw and wiring connections
Furnace Tune-Up, Cleaning and Safety Inspection
Keep Your Furnace at Peak Efficiency with an Annual Tune-Up – and Safeguard your Family with a FREE Carbon Monoxide Test. Tune-up your furnace and Neerings guarantees you a 100% profit in energy savings plus receive a free carbon monoxide test.
Neerings' trained technicians will perform a 60-90-minute precision tune-up and professional cleaning including the following 19 operations:
- Carbon Monoxide - test air flow duct system for dangerous carbon monoxide
- Thermostat – test for proper operation, calibrate and level
- Inspect for combustible material around furnace
- Ignition System test
- Exhaust System test
- Measure Supply/Return temperature differential
- Safety & Control Circuits – test for proper operation
- Inspect and adjust fan belt tension (if applicable)
- Clean existing air filter
- Lubricate and clean blower motor
- Furnace Burner – clean and inspect
- Heat Exchangers – clean and inspect (brush and vacuum)
- Video certification of heat exchangers for dangerous cracks and wear
- Gas Pressure – measure and adjust for peak efficiency
- Lubricate all moving parts per manufacture
- Blower Motor – measure amperage and voltage for proper operation
- Electrical Wiring – inspect and tighten connections
- Combustion Vents – clean and inspect (upper and lower)
- Natural Gas – check for leaks